What Is Titration of an IV Drip?
Titration is adjusting a continuous infusion up or down in set steps, by protocol, to reach a target such as an aPTT range or blood pressure. Each step is a new rate calculation. In the example heparin protocol used in Dosage Drills, the drip starts at 18 units/kg/hr and changes by aPTT.
How a protocol step works
The example table, modeled on Raschke 1993, has 5 rows. For aPTT 46 to 70 seconds, there is no change. Outside that, you re-bolus, increase, decrease or hold by units/kg. Convert the new units/hr to mL/hr with the bag concentration.
This is practice only: follow your facility's protocol and order.
Safety habits
Use the dosing weight the protocol specifies and keep it consistent at every step. Recalculate from units/kg/hr each time rather than adjusting mL/hr by feel. Document the aPTT, the protocol row, the new rate and the time of the next level. The heparin worksheet walks through a full protocol sequence.
Worked example
80 kg patient, heparin 25,000 units in 250 mL, started at 18 units/kg/hr. aPTT comes back 40 seconds.
- Start: 18 × 80 = 1440 units/hr = 14.4 mL/hr (100 units/mL)
- aPTT 40 falls in row "35 to 45": Re-bolus 40 units/kg; increase infusion by 2 units/kg/hr
- Re-bolus 40 × 80 = 3200 units
- New rate: 1440 + 2 × 80 = 1600 units/hr = 16 mL/hr
Answer: Re-bolus 3200 units and run 16 mL/hr.
Common mistakes
- Applying the change per kg as a flat units change.
- Forgetting the re-bolus.
- Changing the rate without converting units/hr to mL/hr.
Frequently asked questions
What does titrate mean?
Adjust an infusion in steps to reach a target, according to an order or protocol.
What target is used for heparin?
An aPTT or anti-Xa range set by the facility protocol.
What is the starting dose in the example protocol?
80 units/kg bolus, then 18 units/kg/hr.
Is heparin high-alert?
Yes, ISMP lists it as a high-alert medication.
Learn and practice
- Heparin drip guide
- Heparin drip calculator
- Practice in Dosage Drills
- What is aPTT?
- Heparin worksheet
- What is mcg/kg/min?
- Dosage calculation learning path
- Full glossary
References
- Raschke RA, et al. The weight-based heparin dosing nomogram compared with a "standard care" nomogram. Ann Intern Med. 1993;119(9):874-881.
- Heparin sodium in 5% dextrose injection (premixed): FDA-approved prescribing information, DailyMed set ID 92a6f533-1a3d-4734-b413-d245592454e3 (U.S. National Library of Medicine).
- Institute for Safe Medication Practices (ISMP). ISMP List of High-Alert Medications in Acute Care Settings.
Educational practice only. This page supports exam practice and is not a clinical decision tool. Ranges and protocols vary; follow your facility's reference ranges, policies and current product information.